Bafang BBS power cable for extension or conversion.

The connector can be BBS01/02 default bullet connector, BBSHD Anderson connector, Amass XT60 connector, Amass XT90 connector.

Cable length could be 10-100cm for your demand;

Wre: 12AWG black/red wire;

If your current Bafang motor and the battery are with different connector, then you may need a conversion cable.

If your ebike battery power cable is too short, then you may need a extension cable. 

e-bike motor hall connector DJ7061A-2.8-11/21 male/female plug; this plug is normally used for motor hall, ebike brake, e bike gas/throttle end connection.

6P plug for motor hall;

3P plug for e-bike throttle/gas;

2P plug for e-brake;

Plug sping and male tab are included.

E-bike power cord for connecting motor controller to ebike battery.

For connecting motor controller side, the connector could be DJ7031 connector(we no longer use it) , Φ4mm bullet connector(default power connector of our front or rear ebike controllers) or Φ5mm bullet connector(default power connector for Bafang BBS01/02 kit).

For connecting battery side, you can choose your demand connectors.

Currently, 90% front or rear brushless motor controller use Φ4mm bullet connectors for motor controller. You can check your own controller power connectors before ordering.

Default cable would be 14AWG.

If you need 12AWG wire for the power cable, please leave a message.

electric bike motor phase connector green bullet connector male/famale with isolated cover;

Ebike brushless controlle power connector bullet type male/female with housing;

Bullet connector 4.0mm/4.2mm for battery/motor phase/controller power connection.

The price includes male and female bullet connector, amle and female isolated protector.

This connector is suitable for Tongsheng TSDZ2 mid motor power plug.

4/5 pins connector for e-bike lithium ion battery, for rear rack casing, downtube silver fish casing. There may be different connectors for rear rack or filverfish casing battery, please check the dimension of the original connector before ordering.

ebike Atlas frame battery mouting foot.

This mounting is suitable for our downtube Atlas casing battery(DA-5C).

The price is only for the mouting, not including the battery case.

We will solder the power connector before shipment if you also add the power connector with the frame battery attachment.

The default discharging connector of the mountin is 2P original plug, please note. If you need 6P plug for larger current, please email us after placing the order.

ebike battery downtube case mounting on bike frame with slim dimension(hailing 1 case).

Discharging port is 4pin, charging port is round 5.5x2.1 or 5.5x2.5DC connector. If you want larger charging current, please choose 2.5DC charging port.

Cell holders and battery mounting foot are included with the case. If you also need the matching BMS/PCM for this casing battery, you can click here for the bms.

Atlas frame battery key lock  or Jumbo shark battery.  . 

If you are not sure which case the key set uses for, please check dimension or pictures for our Atlas frame battery case and Jumbo shark battery case.

Ebike battery frame fixing plate/mountin base for downtube battery DS-6 case. We can solder the power plug with the required connector for you before shipment.

If you are looking for larger power connector for this mounting base, we can provide 6 pin connector for the mounting(the latest version for this case is 6 pin connector for larger current, the older version is with 6pin connector for larger current, the dimensions for the connectors are the same, just the pin numbers are different). Please check your battery discharging connectors before ordering the battery fixing plate.